ENGLISH
6
English
Main unit Remote control
Install the remote control unit on the vehicle by the
provided Velcro tape.
01
A
Installation
Before fixing the speaker in its position, be sure to check the sound while it is connected preliminary.
Caution:
•
When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check that there is nothing hazardous on
the opposite side such as a gasoline tank, brake pipe; or wiring harness, and be careful not to cause scratches or other damage.
• Install in a location that does not come in the way of driving, getting in or out of the vehicle and movement inside the ve-
hicle compartment.
• Fix the product firmly so that it will not be moved by vibrations or impacts during driving.
7
Fixing the subwoofer
2
Machine screw x 4
1
Fixture x 2
Caution:
12
Attach the fixtures
1
to the speaker unit securely
using the machine screws
2
. Be careful so that the
connected cords do not get in between the speaker
unit and fixtures
1
.
3
Tapping screw x 4
Drill the pilot holes for ø 3.6 mm screws on the sheet
metal section of the vehicle , and attach the speaker
unit to the vehicle using the tapping screws
3
.
7
Installing the remote control unit
6
Remote control
Rear panel
5
Velcro tape
(Softer surface)
Vehicle
Caution:
Install the remote control unit in a position that does not
come in the way of driving operations. Avoid installing
it in a place subject to direct sunlight or direct hot wind
from the heater. Otherwise, the product may be degraded
and a fire hazard may result. Remove dirt from the installa-
tion position before attaching the Velcro tape.
PHASE switch
(Phase select switch)
FREQUENCY control knob
(Cut-off frequency control knob)
VOLUME control knob
(Input sensitivity control knob)
Fuse exchange
7
Removal
7
Insertion
Fuse
Cover
Fuse holder
Replacement
fuse 10 A
1
Open the cover.
2
Grasp the fuse and pull up.
1
Insert the fuse gently into the fuse holder and
push in all the way with your finger.
2
Close the cover.
Caution: Be sure to replace with same capacity (amperage) as displayed on the fuse. This product is 10A.
Exchange with the speci-
fied capacity fuse.
Drill four pilot holes for
ø 3.6 mm screws.
5
Velcro tape
(Harder surface)
Name of each part
This portion becomes slightly
hotter than other portions
because it functions as the
radiator of the heat generated
by the amplifier.
B61-1344_EN.indd 6B61-1344_EN.indd 6 09.5.28 11:53:19 AM09.5.28 11:53:19 AM
(13 pages)
(15 pages)
(72 pages)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals