Kenwood KOS-A300 User Manual download pdf (Page 36)

KOS-A300

Installation of Controller

According to the installation angle of the controller,

install Spacer (Accessory 5) to Bracket (Accessory

6) as described below.

When installing on the 0-degree surface

Accessory8

(Ø2 X 10, Black)

Accessory6

Accessory5

When installing on the 4-degree surface

Accessory0

(Ø2 X 5, Black)

Accessory6

Accessory5

When installing on the 8-degree surface

Accessory7

(Ø2 X 11.5, Blue)

Accessory9

(Ø2 X 9, White)

Accessory6

Accessory5

⁄

• The direct installation of Bracket (Accessory ⑥) without

Spacer (Accessory 5) is also possible.

2 From Spacer (Accessory 5), remove the chip in the

direction where you want to wire the controller

cable.

Accessory5

Chip

Break off the spacer chip in the direction where you

want to wire the controller cable.

Drill a hole of 10 mm in diameter on the mounting

surface when not using spacer or wiring the cable

behind the mounting surface.

Installation

B64-4452-00_00_KOS-A300_K.indd 36B64-4452-00_00_KOS-A300_K.indd 36 09.2.18 2:04:11 PM09.2.18 2:04:11 PM

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43 44

No comments

Kenwood KOS-A300 User Manual Page 36