Kenwood KAC-6202 User Manual download pdf (Page 4)

4 English

Controls / Indicator

(W)

1 FILTER switch

This switch allows to apply high-pass or low-pass

filtering to the speaker outputs.

• HPF (High-Pass Filter) position:

The filter outputs the band of higher frequencies

than the frequency set with the FILTER

FREQUENCY control.

• OFF position:

The entire bandwidth is output without filtering.

• LPF (Low-Pass Filter) position:

The filter outputs the band of lower frequencies

than the frequency set with the FILTER

FREQUENCY control.

2 FILTER FREQUENCY control

Sets the cutoff frequency when the FILTER switch

is set to LPF or HPF.

3 INPUT SENSITIVITY control

Set this control according to the pre-output level

of the center unit connected with this unit, or

to the maximum power output of the genuine-

accessory car stereo.

Use the diagram on the right as a guide.

NOTE

For the pre-output level or the maximum power

output, refer to the <Specifications> in the

instruction manual of the center unit.

4 OPERATION switch

This switch is used to select the operation mode

of the amplifier.

• STEREO position:

The amplifier can be used as a stereo amplifier.

• MONO (Lch) position:

Amplifies the signal input from the left side

only. Set to this position and make bridged

connections to use as a high-power monaural

amplifier. (The input right signal is not output.)

B64-3043-00-00_M_English.indd 4B64-3043-00-00_M_English.indd 4 04.12.27 1:34:48 PM04.12.27 1:34:48 PM

1 2 3 4 5 6 7 8 9 ... 13 14

No comments

Kenwood KAC-6202 User Manual Page 4