Kenwood TM-D710A User Manual download pdf (Page 8)

MOBILE INSTALLATION

n TX/ RX Unit Installation

Select a safe, convenient location inside your vehicle that will minimize danger

to your passengers and yourself while the vehicle is in motion. Consider

installing the transceiver under the dash in front of the passenger seat so that

knees or legs will not strike the radio during sudden braking of your vehicle.

Try to a pick well-ventilated location that is shielded from direct sunlight.

Note: You may experience interference on your GPS receiver when using in or around 438.8

MHz (A band) and/or 443.8 MHz (B band). To eliminate the interference, ensure that the

transceiver is installed at a location separate from your GPS receiver.

1 Install the mounting bracket in the vehicle using the supplied self-tapping

screws and flat washers (4 of each are supplied).

• The bracket can be mounted with the bracket opening facing down, for under dash

mounting, or facing up.

• The bracket must be installed so that the 3 screw slots on the edge of each bracket

side are facing the back.

2 Position the transceiver, then insert and tighten the supplied hexagon

SEMS screws and flat washers (4 of each are supplied, 2 for each side of

the bracket).

• Ensure that all hardware is tightened, to prevent vehicle vibration from

loosening the bracket or TX/ RX unit.

• Set an appropriate angle for the TX/ RX unit, using the 3 screw slots on

the rear edge of each bracket side.

Self-tapping screw

(5 x 16 mm)

Flat washer

SEMS screw (M4 x 10 mm)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 50 51

No comments

Kenwood TM-D710A User Manual Page 8