Kenwood TM-D710A User Manual download pdf (Page 12)

REPLACING FUSES

If the fuse blows, determine the cause, then correct the problem. After the

problem is resolved, replace the fuse. If newly installed fuses continue to blow,

disconnect the power cable and contact your authorized Kenwood dealer or an

authorized Kenwood service center for assistance.

Fuse Location Fuse Current Rating

Transceiver

(located on the DC connector)

15 A

Supplied DC power cable 20 A

Only use fuses of the specified type and rating; otherwise the transceiver could be damaged.

Panel jack

MIC jack

Microphone

Operation panel

TX/ RX unit

Fuse holder (E type) Fuse holder (K, M4 types)

Fuse

Fuse holder

Fuse

Fuse holder

OPERATION PANEL AND MICROPHONE CONNECTION

Plug the microphone plug to the MIC jack, then connect the Operation panel to

the TX/ RX unit with the supplied cable.

• Attach the microphone hanger to an appropriate position using the screws included in

the screw set.

Modular plug cable

Installing the Line Filter

Install the line filter

approximately 3 cm from the

connector.

Approx. 3 cm

Line filter

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 50 51

No comments

Kenwood TM-D710A User Manual Page 12