Kenwood KRF-V5560D User Manual download pdf (Page 33)

In case of difficulty

Amplifier

- - Sf»ptoin

Cans# '' ......... .<1

Remedy -

No sound from the speakers.

• The speaker cords are disconnected.

• VOLUME IS set to the minimum position.

• MUTE IS ON

• The SPEAKERS switches are set to OFF.

• Connect them properly referring to "Connect

ing the speakers" -OS

• Adjust the volume to a proper level.

• Turn OFF the MUTE. -!2a]

• Set the SPEAKERS switch to ON. -Cg]

The standby indicator blinks and sound is

not output.

• Speaker cords are short-circuited.

• Turn the power off. eliminate the short-circuit

ing, then turn on the power again.

Sound is not output from one of the speak

ers.

• The speaker cord is disconnected.

•Connect it properly referring to "Connecting

the speakers". ~l3£l

Sound is not output from the surround

speakers and / or the center speaker, or their

sound is very small.

• The surround speaker cords and/or the center

speaker cord is disconnected.

• A surround mode has not been engaged.

• The surround and/or center volume controls

are set to the minimum level.

• Connect it properly referring to "Connecting

the speakers". -QJ)

• Select a surround mode.

• Adjust the speaker levels using the test tone.

A humming noise is generated when the

PHONO input selector is selected.

• The audio cord from the record player is not

connected to the PHONO jacks.

• The record player is not grounded

• Insert the audio cord plugs securely Into the

PHONO jacks,

• Connect the grounding wire to the GND termi

nal on the rear panel.

When playing a Dolby Digital source signal

using a DVD player, the sound is cut off soon

after it starts.

• There are many possible causes for this prob

lem, depending on the type of DVD player

used.

• Set the input mode to digital manual before

starting playback of the Dolby Digital source.

No sound is produced during playback from

a DVD player.

• The input mode is set to digital manual.

• Press the INPUT MODE key to select to digital

auto mode, -tj]

A video source cannot be recorded normally.

• The software is copy-guarded.

• Copy-guarded video software cannot be re

corded.

Tuner

Symptom T „, , t«: 1

fj . -, ■ ■ ' ■ . _ ........................................

...

TiliilP

Remedy

Radio stations cannot be received.

• No antenna is connected.

• The broadcast band is not set properly,

•The frequency of the desired station is not

tuned

• Connect an antenna. -132

• Set the broadcast band properly.

• Tune the frequency of the desired station.

-a

Interference.

• Noise due to ignition noise from an automo

bile.

• Noise due to interference from an electric

appliance

• Noise due to a nearby TV set

• Install the outdoor antenna away from the

road.

• Turn off the power to the appliance.

• Install the receiver farther away from the TV.

A station which was preset cannot be re

ceived by pressing the corresponding nu

meric key.

• The preset station belongs to a frequency that

cannot be received.

• The preset memory was cleared because the

power cord had been unplugged for a long

period of time

• Preset a station with a receivable frequency.

• Preset the station again

33

EN

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments