Kenwood TK-2360/3360 User Manual

© B62-2182-00 (K, K2)09 08 07 06 05 04 03 02 01 00INSTRUCTION MANUALVHF FM TRANSCEIVERTK-2360UHF FM TRANSCEIVERTK-3360

21 Match the guides of the battery pack with the grooves on the upper rear of the transceiver, then rmly press the battery pack in place.2 Lock the

3Note:◆ If you do not plan to use the transceiver for a long period, remove the batteries from the battery case.◆ This battery case has been designed

4Note: When rst installing the belt clip, you must remove the battery pack from the rear of the transceiver.1 Remove the 2

52 While holding the cap in place, push it towards the bottom of the transceiver until the tabs on the cap click into place.• To remove the cap, hol

6There are 3 types of stoppers available, depending on the number of channels used (4 channel type: white, 8 channel typ

7① Channel Selector Rotate to select a channel.② Power switch/ Volume control Rotate to turn the transceiver ON/OFF and to adjust the vol

8⑥ Side 1 key Press or hold to activate its programmable function {page 8}.⑦ Side 2 key Press or hold to activate its programmable function {page 8}

9n  Press and hold this key to enter Emergency mode. When the transceiver enters Emergency mode, it will change to the Emergency channel a

10n  Press and hold this key to deactivate QT or DQT signaling. Release the key to return to normal operation.n  After sel

11n  Press and hold this key to hear background noise. Press this key again to return to normal operation.n 

Thank YouWe are grateful you have chosen Kenwood for your land mobile radio applications.noTices To The user◆ Government law prohibits the operation

121 Select your desired channel.2 Press the key programmed as Monitor or Squelch Off to check whether or not the channel is fr

13If a Priority channel has been programmed, the transceiver will automatically change to the Priority channel when a call is received on

14FleetSync is an Alphanumeric 2-way Paging Function, and is a protocol owned by Kenwood Corporation.Note

15 You can transmit pre-programmed Status messages by pressing the keys programmed as Status 1 or Status 2.Status messages are 2-digit c

161 Connect a headset to the transceiver.2 To transmit, simply speak into the microphone.• The transceiver recognizes sound levels depe

17PTT ID is the transceiver unique ID code which is sent each time the PTT switch is pressed and/or released.If programmed by your deal

18Your dealer may also program several types of optional signaling for your transceiver channels.2-tone Signaling: 2-tone Signaling

iOne or more of the following statements may be applicable:FCC WARNINGThis equipment generates or uses radio frequency energy. Changes or modication

iiThe RBRC Recycle seal found on Kenwood nickel metal hydride (Ni-MH) battery packs indicates Kenwood’s voluntary participation in an industry program

iii• Do not disassemble or modify the transceiver for any reason.• Do not place the transceiver on or near airbag equipment while the vehicle is run

ivinformation concerning the battery PackThe battery pack includes ammable objects such as organic solvent. Mishandling may cause the battery to rup

v• Do not charge the battery near fires or under direct sunlight! If the battery’s protection circuit is damaged, the battery may charge at extreme

vi• Do not charge the battery for longer than the specified time! If the battery pack has not nished charging even after the regulated time has pas

1UNPACKING AND CHECKING EQUIPMENT . . . . . . . . . . . . . . . . . . . 1PREPARATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . .