Kenwood KAC-PS500F User Manual Page 5
- Page / 7
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
L
L
R
R
LINE IN
P.CON(REMOTE)
GND
MONO
LINE OUT
25Hz
15Hz
INFRASONIC
FILTER
OFF
OPERATION
MONOSTEREO
OPERATION
MONOSTEREO
25Hz
15Hz
INFRASONIC
OFF
LPF
OFF
HPF
FILTER
LPF
OFF
HPF
CONTROL
INPUT
SENSITIVITY(V)
0.25
0.5
1
2
FREQUENCY(Hz) FREQUENCY(Hz)
50
70
100
LPF 200
170
120
50
70
200
150
120100
HPF
150
3
4
INPUT
SELECTOR
BB
B
AA
A
A A
+
(MAX)
(MIN)
INPUT
SENSITIVITY(V)
0.25
0.5
1
2
3
4
(MAX)
(MIN)
CONTROL
B
50
70
100
LPF 200
170
120
50
70
200
150
120
100
HPF
150
LEFT
BRIDGED
SERVO Ι FEED BACK
RIGHT
SPEAKER OUTPUT
FUSE(20A×4)
BATT.
GND
B
B
B
A
A
A
Σ
20
20
20
20
Σ Σ
Σ Σ
- +
English
98
English
Connection
LEFT
BRIDGED
SERVO Ι FEED BACK
RIGHT
SPEAKER OUTPUT
FUSE(20A×4)
BATT.
GND
B
B
B
A
A
A
Σ
20
20
20
20
Σ Σ
Σ Σ
■
Bridged Connections
■
Power and Speakers cable connection (Stereo Connections)
CENTER UNIT
(Cassette receiver,
CD receiver, etc.)
RCA cable (Commercially
available part)
A Left input (White)
A Right input (Red)
B Left input (White)
B Right input (Red)
RCA cable ground terminal
When using an RCA cable with
a ground lead attached, connect
the ground lead to this terminal.
ALINE IN (Front)
BLINE IN (Rear)
Do not use this terminal for power source
grounding. This unit will be damaged if the
power source grounding wire is connected to
this terminal.
2CAUTION
Front left
speaker
Rear left
speaker
Rear right
speaker
Front right
speaker
Battey
Power control (REMOTE)
lead terminal
To prevent fire caused by a short in the
wiring, connect a fusible link or breaker
nearby the battery’s positive terminal.
Connect the ground cable to a metal part of
the car chassis that acts as an electrical
ground passing electricity to the battery‘s
negative - terminal. Do not turn the power
on if the ground cable is not connected.
NOTE
2WARNING
• If a buzzing noise is heard from the speakers when the engine is running,
connect a line noise filter (optional) to each of the battery cable.
• Do not allow the cord to directly contact the edge of the iron plate by using
Grommets.
Terminal cover
Fire wall
Grommets
Ground cable (Commercially available part)
Battery cable (Commercially
available part)
Round terminal (Large)
Power terminal
Pass battery and ground cables through supplied
terminal cover and connect to respective
terminals. After completing connections, fasten
terminal cover over terminal bracket.
Round terminal (Medium)
A Bridged
B Bridged
■
Connection Precautions
Speaker Output/Sigma Servo
Feedback Terminals
Connect the speaker output
cables to these terminals.
Lead terminal
(Commercially
available part)
Power control lead terminal
Connect the Center units's power
control lead from the center unit.
Round terminal
(Small)
• Speakers that are to be used for stereo connections to
this unit should have an impedance of 2Ω or greater.
When connecting multiple speakers, ensure that the
combined impedance is 2Ω or greater. Connection of
speakers of less than 2Ω will be the cause of breakdown.
• Speakers that are to be used for bridged connections to
this unit should have an impedance of 4Ω or greater.
When connecting multiple speakers, ensure that the
combined impedance is 4Ω or greater. Connection of
speakers of less than 4Ω will be the cause of breakdown.
2CAUTION
Power control cable
(Commercially
available part)
Related products and manuals for Receivers and Amplifiers Kenwood KAC-PS500F
(14 pages)
(2 pages)
(15 pages)
Brother 4000D podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Maszyny do szycia Brother 4000D.
Dostarczamy 3 pdf podręczników Brother 4000D do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika, Przewodnik Instalacji
Comments to this Manuals