Kenwood KR-V990D User Manual download pdf (Page 11)

PRE OUT connections

these jacks if you want to listen at even greater volumes or enjoy a different sound quality.

^^»necting a speaker cord directly to a PRE OUT jack will not produce any sound from the speaker. Connect the PRE OUT jacks to powered speakers

^^power amplifiers connected to speakers.

Be sure to set one of the SPEAKERS keys (either A or B) to the ON position when using the PRE OUT jacks.

___

Front Speakers

Center Speaker

Powered

Sub-woofer

Power amp

^nnectina the repeater

Setting up the repeater lets you control your video components with the receiver's remote control. This repeater sends out signals corresponding to those

of the remote supplied with your video equipment. There are 2 repeaterjacks on the rear panel. One is for the supplied repeater. Depending on the repeater

and the locations of your video components, it may not be possible to control all your video components with just one repeater. If you would like to use

2 repeaters, please consult your dealer.

—

=CZI>—

Repeater (supplied)

3--' ^oo

1 Ql

O O

Q QQ

(QnQ tzzz?

1 O OO OO

o oo ool

Q OO OO

'—

Placement

^^in

This repeater outputs infrared ray remote control codes in three

lirections (shown at right). Use the supplied double-sided tape to

¡cure the repeater in a position where it can operate your video

;omponents. The range of operation depends on the shape and size

of your room. Place the repeater so that there are no obstacles

between the repeater and the remote receptors on your video

components. Obstacles may prevent remote operation of your video

components.

________________________________________________

Remote control code output directions

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Comments to this Manuals

No comments

Kenwood KR-V990D User Manual Page 11

Comments to this Manuals