Kenwood DNX7360BT User Manual download pdf (Page 2)

2

DNX SERIES/ DDX SERIES

Installation Procedure

1

..........1

2

..........1

3

..........1

4

..........1

5

..........2

6

..........1

7

..........1

8

..........6

9

..........6

0

..........1

!

..........1

@

..........1

#

DNX7360BT,

DNX7360BTM only

..........1

$

DNX7360BT,

DNX7360BTM only

..........1

Accessories

1. To prevent a short circuit, remove the key

from the ignition and disconnect the -

battery.

2. Make the proper input and output wire

connections for each unit.

3. Connect the speaker wires of the wiring

harness.

4. Connect the wiring harness wires in the

following order: ground, battery, ignition.

5. Connect the wiring harness connector to

the unit.

6. Install the unit in your car.

7. Reconnect the - battery.

8. Press the reset button.

9. Perform the Initial Setup. (Refer to the

Instruction Manual.)

2WARNING

• If you connect the ignition wire (red) and the

battery wire (yellow) to the car chassis (ground),

you may cause a short circuit, that in turn may

start a fire. Always connect those wires to the

power source running through the fuse box.

• Do not cut out the fuse from the ignition wire

(red) and the battery wire (yellow). The power

supply must be connected to the wires via the

fuse.

Acquiring GPS Signals

The first time you turn on DNX7360BT,

DNX7360BTM, you must wait while the

system acquires satellite signals for the first

time. This process could take up to several

minutes. Make sure your vehicle is outdoors

in an open area away from tall buildings and

trees for fastest acquisition. After the system

acquires satellites for the first time, it will

acquire satellites quickly each time thereafter.

About the Front Panel

When removing the product from the

box or installing it, the front panel may be

positioned at the angle shown in (Fig. 1). This

is due to the characteristics of a mechanism

the product is equipped with.

If the program that is activated when the

1 2 3 4 5 6 7 ... 11 12

Comments to this Manuals

No comments