Kenwood DDX7034BT User Manual download pdf (Page 99)

DNX7140/ DNX7000EX/ DDX714

2CAUTION

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation

exposure.

In compliance with Federal Regulations, following are reproductions of labels on, or inside the product relating to laser product

safety.

Kenwood Corporation

2967-3, ISHIKAWA-MACHI,

HACHIOJI-SHI

TOKYO, JAPAN

KENWOOD CORP. CERTIFIES THIS EQUIPMENT

CONFORMS TO DHHS REGULATIONS N0.21 CFR

1040. 10, CHAPTER 1, SUBCHAPTER J.

Location : Bottom Panel

FCC WARNING

This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful

interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to

operate this equipment if an unauthorized change or modification is made.

NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the

instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

IC (Industry Canada) Notice

Operation is subject to the following two conditions:

(1) This device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired operation of the

device.

The term "IC: " before the certification/registration number only signifies that the Industry Canada technical

specification were met.

The marking of products using lasers (Except for some areas)

The label is attached to the chassis/case and says that the component

uses laser beams that have been classified as Class 1. It means that the

unit is utilizing laser beams that are of a weaker class. There is no danger

of hazardous radiation outside the unit.

CLASS 1

LASER PRODUCT

DDX7034BT

B64-4502-00_01_K_English.indd 99B64-4502-00_01_K_English.indd 99 09.4.20 8:59:58 AM09.4.20 8:59:58 AM

1 2 ... 94 95 96 97 98 99 100

Comments to this Manuals

No comments

Kenwood DDX7034BT User Manual Page 99

Comments to this Manuals

Related products and manuals for GPS receiver Kenwood DDX7034BT