KRC-266KRC-266S© B64-2433-00/00 (MN)CASSETTE RECEIVERINSTRUCTION MANUAL
Switching to the radio automatically during Fast Forwarding andRewinding.Press the [TC] button.Each time the button is pressed the Tuner Call turns ON
Fast ForwardingHold down on the [¢] button.Release your finger to play the disc at that point.ReversingHold down on the [4] button.Release your finger
Playing all the songs on the disc in random order.Press the [RDM] button.Each time the button is pressed Random Play turns ON or OFF.When it's ON
Play the songs on all the discs in the disc changer in randomorder.Press the [M.RDM] button.Each time the button is pressed the Magazine Random Play t
English— 14 —The use of any accessories except for those provided might result indamage to the unit. Make sure only to use the accessories shipped wit
— 15 —P.CONTANT.CONTFM/AM antenna input 1Rear left output (White) 23Rear right output (Red) 28Fuse (10A) 24KENWOOD disc changer control input2Wiring h
English— 16 —Make sure that the unit is installed securely in place. If the unit isunstable, it may malfunction (for example, the sound may skip).Meta
— 17 — Removing the hard rubber frame2 When the lower level is removed, remove the upper twolocations.The frame can be removed from the top side in t
English— 18 —What might seem to be a malfunction in your unit mayjust be the result of slight misoperation or miswiring.Before calling service, first
— 19 —Tuner source? Radio reception is poor.39✔ The car antenna is not extended.☞ Pull the antenna out all the way.✔ The antenna control wire is not c
— 2 —EnglishContentsSafety precautions...3About Cassette tape ...
English— 20 —The messages shown below display your systemscondition.E-01: No disc magazine has been loaded in the changer.The disc magazine is not co
— 21 —FM tuner sectionFrequency range (50 kHz space) ...87.5 MHz –108.0 MHz(200 kHz space) ...87.9 MHz –107.9 MHzUsable sensitiv
— 3 —To prevent injury or fire, take thefollowing precautions:• Insert the unit all the way in until it is fullylocked in place. Otherwise it may fall
— 4 —English• If you experience problems duringinstallation, consult your Kenwood dealer.• If the unit does not seem to be workingright, try pressing
Press the [SRC] button.Source required DisplayTuner "TUnE"Tape "TAPE"External disc "DISC"Standby (Illumination only mode
1 Select the source for adjustmentPress the [SRC] button.2 Enter Audio Control modePress the [A.ADJ] button for at least 1 second.3 Select the Audio i
The faceplate of the unit can be detached and taken with you,helping to deter theft.Removing the FaceplatePress the Release button.The faceplate is un
Selecting the station.1 Select tuner sourcePress the [SRC] button.Select the "TUnE" display.2 Select the bandPress the [FM] or [AM] button.E
Changing the tuning frequency step.The original setting is FM band 50 kHz, and AM band 9 kHz.1 Turn the power OFFPress the [SRC] button for at least 1
Comments to this Manuals