Kenwood KAC-818 User Manual Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 9
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
4
English
Controls
Operations of the following control and switches are required in accordance with the center
unit and speakers connected with this unit.
MONO
POWER AMPLIFIER
L
25Hz
15Hz
INFRASONIC
OFF
INPUT
SENSITIVITY(V)
LPF
FREQUENCY(Hz)
GND
R
LINE IN
0.3
0.5
1
2
3
4
5 0.2
150
100
70
50 200
LEFT RIGHT
SPEAKER LEVEL INPUT
POWER IN
FUSE(20A)
BATT
GND
FUSE(20A)
P.CON(REMOTE)
SPEAKER OUTPUT
20
20
SERVO ΙΙ
SERVO ΙΙ
1 2 3
456
@7 8 9 0 !
1
FUSE (20 A
×
2)
2
Battery terminal
3
Ground terminal
4
Power control (REMOTE) terminal
5
Speaker output terminals
As this unit accepts speakers with a minimum impedance of 2 ohms, connect speakers with
2-ohm or higher impedance to these terminals.
The rated input of the speakers should be no less than the maximum output of the amplifier.
Otherwise malfunction may result.
6
SIGMA SERVO FEED BACK terminals (See p.8)
Be sure to make proper connections to the SIGMA SERVO FEED BACK terminals. Incorrect
connection may result in lack of sound output or other malfunctions.
7
INFRASONIC FILTER switch
Ultralow frequencies that cannot be reproduced even by a subwoofer speaker do not become
sound but become unnecessary oscillations, which affect the sound by causing distortion, etc.
Setting this switch to "15 Hz" or "25 Hz" cuts the frequencies below the respective frequency.
This improves the reproduction performance of the speakers by eliminating unnecessary
oscillations which will not become sound.
8
LOW PASS FILTER FREQUENCY control
This control adjusts the frequency band output from this unit.
9
INPUT SENSITIVITY control
Set this control according to the pre-output level of the center unit
connected with this unit, or to the maximum power output of the genuine-
accessory car stereo.
Use the diagram on the right as a guide.
2CAUTION
2CAUTION
0.3
0.2
0.5
1
2
3
4
5
(V)
(W)
25
15
10
Page view 3
1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments