Kenwood DPX502U User Manual download pdf (Page 34)

English

Accessories/ Installation Procedure

Accessories

..........1

..........2

..........1

Installation Procedure

1. To prevent short circuits, remove the key from the

ignition and disconnect the - terminal of the

battery.

2. Make the proper input and output wire

connections for each unit.

3. Connect the wire on the wiring harness.

4. Take Connector B on the wiring harness and

connect it to the speaker connector in your vehicle.

5. Take Connector A on the wiring harness and

connect it to the external power connector on your

vehicle.

6. Connect the wiring harness connector to the unit.

7. Install the unit in your car.

8. Reconnect the - terminal of the battery.

9. Press the reset button.

• If the power is not turned ON ("PROTECT" is displayed),

the speaker wire may have a short-circuit or touched the

chassis of the vehicle and the protection function may

have been activated. Therefore, the speaker wire should be

checked.

• If your car is not prepared for this special connection-

system, consult your Kenwood dealer.

• Use a commercially available conversion connector if the

connector does not fit in the vehicle connector.

• Make sure that all wire connections are securely made by

inserting jacks until they lock completely.

• If your vehicle’s ignition does not have an ACC position, or

if the ignition wire is connected to a power source with

constant voltage such as a battery wire, the power will not

be linked with the ignition (i.e., it will not turn on and off

along with the ignition). If you want to link the unit’s power

with the ignition, connect the ignition wire to a power

source that can be turned on and off with the ignition key.

• If the fuse blows, first make sure that the wires have not

caused a short circuit, then replace the old fuse with one

with the same rating.

• Insulate unconnected wires with vinyl tape or other similar

material. To prevent short circuits, also do not remove

the caps on the ends of the unconnected wires or the

terminals.

• Connect the speaker wires correctly to the terminals to

which they correspond. The unit may receive damage or fail

to work if you share the - wires and/or ground them to

any metal part in the car.

• After the unit is installed, check whether the brake lamps,

indicators, wipers, etc. on the car are working properly.

• If the console has a lid, make sure to install the unit so

that the faceplate does not hit the lid when closing and

opening.

• Mount the unit so that the mounting angle is 30° or less.

If You Want to Connect iPod

iPod

AUDIO OUT

KCA-iP200 (Optional accessory)

• No other optional accessory can be connected because

the USB connector and the AUX input are used for iPod

connection.

• Dual Zone System in <Audio Setup> (page 10) will become

unavailable.

B64-3829-00_00.Indd 34B64-3829-00_00.Indd 34 07.5.8 9:22:00 AM07.5.8 9:22:00 AM

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Comments to this Manuals

No comments

Kenwood DPX502U User Manual Page 34

Comments to this Manuals

Related products and manuals for AV receivers Kenwood DPX502U