Kenwood C-707I User Manual download pdf (Page 21)

English

Loading the remote control batteries

1 Remove the

battery cover.

2 Load the R6-size

batteries supplied with

the system.

3 Close the

battery cover.

Component Names and Functions

Using the remote control

After plugging the main unit into an AC wall outlet,

press the power [K] key on the remote control unit

to turn the system on.

After the system

powers up,

press the key for the

function you want to use.

Point the remote control at the remote sensor when

using it.

The remote control may not operate correctly

if direct sunlight or light from a high-frequency

 uorescent lamp (such as an inverter type) is

shining on the remote sensor. If this happens,

move the system to a di erent location to avoid

this type of malfunction.



Approx. 6 m

15°15°

The batteries supplied with the system are for operational testing and may last only for a short time. 

Always replace the batteries with two new ones.

Check the polarity of the batteries (UV) when loading them.

Never heat or take apart the batteries, or put them in the  re or the water.

If batteries are not used correctly, they may burst or leak. This will cause a  re, injury

to persons or damage to the surroundings.



CAUTION

en02_c-707i.indd 21en02_c-707i.indd 21 12/28/2007 4:14:41 PM12/28/2007 4:14:41 PM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 83 84

No comments

Kenwood C-707I User Manual Page 21